Suzhou Electric Appliance Research Institute
期刊號: CN32-1800/TM| ISSN1007-3175

Article retrieval

文章檢索

首頁 >> 文章檢索 >> 文章瀏覽排名

三繞組高阻抗變壓器的短路阻抗計算

來源:電工電氣發布時間:2018-02-13 10:13 瀏覽次數:691
三繞組高阻抗變壓器的短路阻抗計算
 
陳伯根
(福州天宇電氣股份有限公司,福建 福州 350012)
 
    摘 要:介紹了三繞組高阻抗電力變壓器的短路阻抗的計算方法、典型的繞組布置情況和不同運行方式。給出了各種運行方式下的等值漏磁空道面積的變化情況和計算方法,并推導出了漏磁通分為方向相反的兩部分時的等值漏磁空道面積計算的新方法,指出了三繞組高阻抗變壓器在極限分接運行時的短路阻抗和額定短路阻抗的變化關系。將計算結果與試驗值進行比較,偏差都小于2%,說明計算公式符合工程計算要求。
    關鍵詞:三繞組高阻抗變壓器;短路阻抗;等值漏磁空道面積
    中圖分類號:TM426     文獻標識碼:A     文章編號:1007-3175(2018)02-0027-06
 
Short Circuit Impedance Calculation of Three-Winding High Impedance Transformer
 
CHEN Bo-gen
(Fuzhou Tianyu Electric Co., Ltd, Fuzhou 350012, China)
 
    Abstract: Introduction was made to the calculation method of short-circuit impedance, the typical winding arrangement and different operation modes of the three-winding high impedance transformer. This paper gave the change and calculation method of the equivalent magnetic flux leakage path area under various modes of operation and inferred a new method for calculating the equivalent magnetic flux leakage path area when the magnetic flux leakage was divided into two parts with opposite directions, pointing out the relationship between short-circuit impedance and the rated short-circuit impedance of the three-winding high impedance transformer during the limit tap operation. The computed result was compared with the experimental value and the deviation was less that 2%, which shows that the computational formula conforms to the requirements of engineering calculation.
    Key words: three-winding high impedance transformer; short circuit impedance; equivalent magnetic flux leakage path area
 
參考文獻
[1] 李洪春.220 kV三繞組有載調壓高阻抗變壓器設計[J]. 變壓器,2009,46(5):1-7.
[2] 劉傳彝. 電力變壓器設計計算方法與實踐[M]. 沈陽:遼寧科學技術出版社,2002.
[3] 路長柏. 電力變壓器理論與計算[M]. 沈陽:遼寧科學技術出版社,2007.