DCM Boost PFC變換器變占空比控制的數字實現方法
 

宋俊超
（南京理工大學 自動化學院，江蘇 南京 210094）
 

    摘 要：分析了變占空比控制的基本原理，推導出該控制算法的占空比表達式，并提出了一種具有恒功率功能的變占空比控制的數字實現方法?；跀?shù)字信號處理器MC56F8257對80 W DCM Boost PFC變換器進行了實驗驗證。實驗結果表明，數字變占空比控制可以在較寬的輸入電壓范圍內實現接近于1 的功率因數，輸入電流基本無畸變。
    關鍵詞：功率因數校正(PFC)；斷續模式(DCM)；變占空比控制；數字實現
    中圖分類號：TM46     文獻標識碼：A     文章編號：1007-3175(2017)04-0031-04
 

Digital Realization Method of Variable Duty Ratio Control for Discontinuous

Current Mode Boost Power Factor Correction Converters

 

SONG Jun-chao
（School of Automation, Nanjing University of Science and Technology, Nanjing 210094, China）
 

    Abstract: This paper analyzed the basic principle of variable duty ratio control, derived the expression of duty ratio of this control algorithm and proposed a kind of variable duty ratio control digital implementation method with constant power functions. The experimental verification of discontinuous current mode (DCM) Boost power factor correction (PFC) 80 W converter was carried out based on the digital signal processor MC56F8257. The experimental results show that the digital variable duty ratio control can achieve a power factor close to 1 in a wide range of input voltages and the input current is almost no distortion.
    Key words: power factor correction; discontinuous current mode; variable duty ratio control; digital realization
 

參考文獻
[1] YE Z Z, JOVANOVIC M M.Implementation and performance evaluation of DSP-based control for constant-frequency discontinuous-conduction-mode boost PFC front end[J].IEEE Transactions on Industrial Electronics，2005，52(1)：98-107.
[2] 葉開明，陳浩龍，蔡逢煌，王武.DCM Boost PFC 數字化的研究[J]. 電氣自動化，2014，36(4)：47-49.
[3] CHEN F Z, MAKSIMOVIC D.Digital control for improved efficiency and reduced harmonic distortion over wide load range in boost PFC rectifiers[J].IEEE Transactions on Power Electronics，2009，25(10)：760-766.
[4] ATHAB H S.A duty cycle control technique for elimination of line current harmonics in single-stage DCM boost PFC circuit[C]//IEEE Region 10 Conference，2008，18(5)：1-6.
[5] 楊靖，陳新. 電感電流斷續模式下的功率因數校正數字控制解決方案[J]. 通信電源技術，2007，24(1)：8-10.
[6] 姚凱，阮新波，冒小晶，葉志紅. 電流斷續模式Boost 功率因數校正變換器的變占空比控制[J]. 電工技術學報，2011，26(11)：14-24.